Generator Stator | Honda | TRX400 | FA Auto Rancher

Dimensions : Interior diameter : 35mm  Exterior diameter : 93mm  Thickness : 22mm  Length of wires stator to grommet : 40mm  Length of wires grommet to plug : 95mm & 400mm    Other specifications : Number of wires : 5  Number of plugs : 1  Number of pins : 5  Wire to wire resistance : Alternator : Yellow between Each Yellow = 0.4ohms +/-20% Source : Green to Ground = 0.2ohms +/-20% Before installing your new stator   Check the AC output of the stator. Replace any burned or corroded connectors on stator and regulator/rectifier Check and repair any melted wiring. Use hi-temp dielectric grease on all connectors   Our stator may use a different wire color code than your original.  All of the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such. When bolting stator in, always use locking compound. If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.