Stator | Yamaha | YFB250 Timberwolf, YFM225 Bear Tracker + More | 1994-2000

RM01298
Brand new stator Direct replacement to your original unit Plug-and-play, direct fit, easy installation. Highest grade lamination materials Highest grade copper windings, resistant to 200 degrees Celsius. Pick up pulsar coil included Connector included Rubber grommet included All product shipped are tested One year limited warranty We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues. *All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.   Used on Yamaha YFB 250 Timberwolf 1994 -
€185.59
Tax included

 

Financing Available

 

Fast Delivery

 

Returns Process

Number of wires : 7 Number of terminals : 7 Alternator : Yellow Between each Yellow = 0.8 ohms+/-20% Before installing your new stator Check the AC output of the stator. Replace any burned or corroded connectors on stator and regulator/rectifier Check and repair any melted wiring. Use hi-temp dielectric grease on all connectors Our stator may use a different wire color code than your original. All of the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such. When bolting stator in, always use locking compound. If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
RM01298

Specific References

16 other products in the same category: